Two Part Chimney Anti Corrosion Coating Good Acid And Heat Resistant

Product Description

Acid and Heat Resistant Adhesive Chimney Anti Corrosion Coating
 
Guibao 877 is the modified silicone elastic anti-corrosion adhesive with excellent acid and temperature resistance. Its product technology has reached the international leading level. It has been applied to chimney anti-corrosion engineering of coal-fired power plants in 2005. There have been many successful cases.
 
Product Features

Two-part, fast curing and bonding;

Excellent high and low temperature resistance, and long-term use at -55 ° C ~ 200 ° C after curing;

Excellent corrosion resistance for long-lasting use in the wet flue gas environment of power plant desulfurization chimney;

Excellent wear resistance for resisting the scouring of fluid, such as flue gas dust and high flow rate gas;

Good elasticity for adapting to the thermal expansion and contraction stress of various substrates after curing without cracking and falling off;

Excellent aging resistance, usually up to 30 years of service life;

Certificated by CECC;

Good adhesion to concrete, acid-resistant brick, steel base, FRP, ceramic, etc., with wide application range;

No harmful gas volatilization, no harm to the human body, and no pollution to the environment.

Main Usage

Anti-corrosion bonding and filling of foam glass block, vitrified ceramic block and anti-corrosion alloy materials in chimneys and flue anti-corrosion lining systems of thermal power plants;

Bonding of various fireproof materials, thermal insulation materials and anti-corrosion material

Typical Technical Indicators (the measured values should not be considered as product standards)

 
Application Method

Before application, the surface of the substrate should be polished, dedusted and cleaned to avoid affecting the bonding;

Add Part B into Part A according to the manufacturer's recommended ratio;

Mix Part A&B uniformly and then evenly spread on the substrate with a tool.

 
Color
 

Part A is white, Part B is black, and the mixture is black paste.

 
Packing
 

Part A as 25kg/plastic drum, Part B as 300mL/cartridge;

Recommended mixing ratio: A: B = 12~14:1 (mass ratio)

The recommended amount of material for the block& adhesive is 12kg/m2.

 
 
Specification

Net content: Part A as 25kg, Part B as 300g;

 
Executive Standard

Q/71304249-7.012-2017

 
Storage
 
Store in a cool, ventilated and dry place . From the date of production, the storage period is 12 months in the unopened &sealed container.
 
Transportation
 
Transported as Dangerous goods
 
Precautions

Not suitable for frosted or wet substrate surfaces;

When the surface temperature of the material is lower than 5 °C or exceeds 50 °C, it is not suitable for application;

Part A&B should be thoroughly mixed to avoid unevenness and affect the performance of the elastic material;

Part A&B should be stored separately, and prepared when using; after preparation, it should be used within the specified time to avoid waste;

Before bonding the relevant substrate and mass-scale application, the adhesion should be checked in advance;

Uncured adhesive should not be in contact with the skin for a long time. In case of eyes contact, rinse with plenty of water and seek medical advice immediately;

This product is a chemical product, and forbidden to eat and to be implanted in the body; keep the uncured product away from touch of children.